![]() It should already show Player 1 Audio Device as Secondary Katana with the VID and PID it pulled in on it's own. You should not have to change anything here though if you followed my above advice. This will pop up a window that lets you select the input device. Once you have done this, you should be able to run the EditSettings.bat file. Before I disabled this, Rocksmith kept thinking I had "More than one Real Tone Cable Connected". If you have anything else active in the recording tab you may have to disable it. You should have a green check mark on it once this is correct. Set SECONDARY KATANA to the default device. The next thing you have to do is go into your computers "Manage Audio Settings". I ran into this the first time because I had Boss Tone Studio open. If you cannot change this setting, then that means you have something open accessing the amp via USB or something locking it up from editing. Apply that change and close out the driver settings. The default was 44000 Hz and you simply will not get any audio in Rocksmith with this value. ![]() You must change the sample rate to 48000 Hz. Without anything open (nothing accessing the Katana amp or it won't let you change this setting), go to the start menu apps and open Boss>Katana This opens the Katana Drivers Settings. You also have to have your Rocksmith installed and working of course. This all worked the first install when I got my amp no problem and as expected. Of course you have to have your Katana Boss Tone Studio Software installed and all the drivers working etc. Before you do anything with those files some things have to be setup first. No editing of any the installed files is needed. NoCableLauncher-m-binary.rar (Lastest version with multiplayer support) NoCableLauncher.exe & EditSettings.bat Doesn't matter where you put them, just keep then in the same folder. Download this from that page and you will unzip two files. This is simplest method I found for that: That is it as far as software goes. First of all you have to use the "No cable" patch. So you can use just the computer, just the amp, or the computer and the amp. I can now use all the features within Rocksmith with a clean signal going into the game no matter what settings I want coming out of the amplifiers speaker. The USB from the amp to the computer, and the guitar cord from the guitar to the amp. I got it working! 2 cables for my entire setup.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |